Stop KM blocker – Can Blocker for Audi A4 S4 RS4 B9

You can select the option “with working speed indicator”, where the speed is always shown in the speedometer (All assistance systems work permanently).

Audi A4 S4 RS4 B9

 odometer blocker/mileage filter

Mileage Stopper – Speedometer Stopper – Speed ​​Filter – Mileage Blocker – Mileage Stop – Can Emulator – Can Blocker

The right module for the Audi A4 S4 RS4 B9

 Type 1 (32-pin connector): A4/S4/RS4 B9 with Virtual Cockpit from 2017 – 2021

 Type 2 (18-pin connector):A4/S4/RS4 B9.5 with or without Virtual Cockpit from mid 2021 – UP

CHECK CONNECTOR!!

❎ Speedometer with working speed indicator:

The activation of the speedometer with a functioning speed display in the Audi A4 S4 RS4 B9 with a virtual cockpit or normal speedometer is done by pressing the OK button for 10 seconds, which is located on the steering wheel. 

Press the Ok button for 10 seconds → Mode 1. Press the Ok button for 10 seconds → Mode 2. Press the Ok button for 10 seconds → Mode 3. Press the Ok button for 10 seconds → Mode 4.

 Functional sequence:

Mode 1: The actual speed is displayed permanently – only 0% of the actually driven distance is counted. From 100 Miles/Km, only 0 Miles/Km is counted.

(For this you have to activate Mode 1. and then park/turn off the car for 4 minutes)

Mode 2: The actual speed is displayed permanently – only 5% of the actually driven distance is counted. From 100 Miles/Km, only 5 Miles/Km is counted.

Mode 3: The actual speed is displayed permanently – only 10% of the actually driven distance is counted.From 100 Miles/Km, only 5 Miles/Km is counted.

Mode 4: Everything back to the original mileage counting ✅

Percentages of the kilometer/mileage count can vary by a few percent in Mode 3, is dependent on the year of construction and tire size. (+ – 3 to 5%)

❗️ In each mode, all assistance systems function properly ❗️

The right module for the Audi A4 S4 RS4 B9

Originals & High-quality processing of the plug-in system

All functions work with the speedometer module 

Plug & Play plug-in system with connections.

No soldering or cutting of cables or electronic components required 

The ultimate solution to block the mileage for all ECUs in the vehicle 

1. Easy and fast installation. ✅
2. Disassemble the odometer and disconnect it. Then connect the kilometre filter with the plug connection. ✅
3. The installation does not require cutting or soldering of cables.
4. It is activated by pressing a button on the steering wheel. ✅
5. No error messages in the speedometer or navigation ✅
6. Cruise control continues to function without exception ✅
7. No error messages in the dashboard ✅
8. The confirmation of the activation takes place in the speedometer by the turn signal flashes ✅

The KM Freezer always saves the last setting. Nothing has to be reset every time you start your journey. Activation and deactivation can take place at any time, both while driving and while stationary.